Texas-Style Smoked Brisket Recipe

Texas-Style Smoked Brisket Recipe

Brisket takes practice and it is by far one of the most difficult cuts to perfect on the BBQ, hence why it’s so revered in American ‘slow and low’ BBQ. Here’s our own tried and tested recipe (we have cooked over 4,000 briskets!) for a ‘central market’ style Texas brisket that uses simple seasonings, smoke and time to turn this tough cut into probably the most beautiful piece of beef you’ve ever cooked.

    Ingredients

    Instructions

    1. Step 1

      First, mix the rub ingredients together well in a tub or shaker and set aside | Ingredients: 3 1/2 oz of coarsely ground black pepper , 2 1/2 oz of flaky sea salt , 1 1/2 oz of garlic granules , 1 1/2 oz of onion granules
    2. Step 2

      Next, trim off any hard, or particularly thick, areas of fat from the brisket. Don’t be too overzealous as you trim. You need to leave a decent fat cap on the top of the brisket – about 3 mm – so that it renders into delicious beef butter. Keep all of the trimmings as we’ll want to turn this into tallow for the wrapping stage | Ingredients: 11 lb of USA Beef packer brisket
    3. Step 3

      Underneath the brisket, you may see some thick hard fat called ‘deckle fat’. You’ll want to remove most of this too, as well as any silver skinBriskets tend to be ‘squared’ off at the bottom, that is trimming off the thinnest bit of the brisket. They are also often trimmed around the edge so that they have a nice evenly rounded off shape
    4. Step 4

      Rub the yellow mustard all over the brisket then cover generously with the rub, not forgetting the sides | Ingredients: 2 tbsp of American mustard
    5. Step 5

      Place in the fridge for 3 hours or overnight. This will set the rub, ensuring it adheres to the surface of the brisket
    6. Step 6

      When you’re ready to cook, set your smoker or barbecue up for indirect heat and regulate the temperature between 108°C/225°F and 120°C/250°F. If you’re using an offset smoker, point the thickest part (the point end) towards the heat source. If you’re using a kettle BBQ, bank the coals to one side to cook with indirect heat
    7. Step 7

      Add 2–3 wood chunks to the coals and put in the brisket. We usually add wood in the first 2–3 hours. A punchy wood, like oak, works very well here and will produce a stunning smoke ring (the revered pink ring that sits just below the surface of the meat that is caused by a chemical reaction between the meat's myoglobin protein and gases produced when wood and charcoal is burned)
    8. Step 8

      Add the beef trimmings to a foil pan or baking pan and place it underneath the brisket, to render the beef tallow while the brisket cooks
    9. Step 9

      You could be cooking this brisket anywhere from 10 -12 hours: roughly 3 hours per kilogram of meat plus at least an hour or two resting time
    10. Step 10

      When your brisket hits 73°C/165°F, you want to think about doing what’s known as the ‘Texas Crutch’. This is where the brisket is wrapped in rendered tallow to move it out of the ‘meat stall’. The meat stall is a phenomenon that occurs when the brisket’s internal temperature stops rising while it's being smoked, causing it to plateau for hours. The stall typically occurs around 70-74°C /160–165°F
    11. Step 11

      Carefully strain the rendered beef tallow into a heatproof jug
    12. Step 12

      To make a Texas crutch, first get 3 metres of foil or butcher's peach paper. Fold it into thirds
    13. Step 13

      Bring the edges of the foil or paper up a little and put your brisket in the middle third
    14. Step 14

      Pour over some tallow. Bring the flaps of the foil or paper over the brisket and wrap it tightly, expelling as much air as possible. Crimp the edges over the brisket
    15. Step 15

      Pop the brisket back in the smoker. Don’t add any more wood after this point as it won’t penetrate the wrapping
    16. Step 16

      At around the 12-hour mark, you want to start taking the temperature using an instant-read thermometer at both the point and the middle of the flat. You’re also testing for tenderness here, not just temperature. Does the tip of the thermometer slide into the meat easily, or does it still feel a little tough? Most people recommend a minimum temperature of 94°C/201°F as a guide but we’ve had briskets take until 98°C/208°F before they’ve felt ‘probe tender’
    17. Step 17

      When it feels tender, we recommend an extended rest time with the brisket still in its ‘Texas crutch’ wrapping. We usually do this by sitting it in a cool box wrapped in a towel for at least 2 hours
    18. Step 18

      When you’re ready, you’re going to slice the brisket in two ways, since the point and the flat have different grains. Firstly slice in half right where you see the point end rising
    19. Step 19

      Slice the flat at a slight angle into pencil thick slices along the grain
    20. Step 20

      Next take the point end and cut in the opposite direction so you’re cutting against the grain
    21. Step 21

      The serving suggestion here is very particular to central Texas BBQ. You’ll notice absolutely no BBQ sauce is involved in this recipe. This is sacrilege with Texas style brisket to some aficionados. The raw onion and pickles both have enzymes that help your digestive system break down the meat and the white bread is said to be a palate cleanser and removes fatty residue from your palate as you chow down! | Ingredients: white onion, sliced into rings , sweet dill pickle, sliced , white bread